Feedback Form

Industrial Wireless Relay (IWR)

The Industrial Wireless Relay (IWR) may be used to form an ILLUMRA Hybrid: EnOcean + ZigBee long range remote control system. ILLUMRA Hybrid systems provide users reliable light control at distances up to a mile away. The new long range hybrid system enables ILLUMRA self-powered wireless light controls to be used in a greater number of applications than was previously possible.

The IWR provides long range control between I/O devices (such as lights, switches, sensors, pumps, fans, PLCs, etc.). Control inputs are compatible with either dry contacts or DC signal voltages, logic signals, etc. In an ILLUMRA Hybrid: EnOcean + ZigBee system, the IWR is connected to ILLUMRA 4 Channel Low Voltage Relay Receivers ( E3R-R04FP-4).

Power Supplies:
The IWR may be powered with either of the following devices:

  • Power Pack w/Relay (NWO-R12-R27NP)
    Connects to 120V, 220V, or 277V power. Outputs 24V.
  • Wall Wart (NWO-P9VPG)
    Plugs directly into 120V outlet. Outputs 9 VDC.

Range: up to 1 mile (RF line-of-sight)
up to 1,000 ft. (Residential)
up to 300 ft. (urban/industrial)
 
Operating frequency: 2.4 GHz (DSSS - Direct Sequence Spread Spectrum)  
Receiver sensitivity: -100 dBm  
Transmit power: 60mW (100mW EIRP w/ high-gain antenna)  
Supply voltage: 8-30 VDC, 8-28 VAC (3.3 V option available, contact technical support)  
Relay output rating: 0-30 VAC or VDC, 2A Form A (normally open, SPST)  
Interface: Dry contacts (4 inputs, 4 outputs) Inputs also support DC voltage, 0-30 VDC output relay will be closed for an input voltage > 3V, closed when < 1V. TTL & CMOS logic compatible  
Typical latency: 5 ms (input to output between units)  
Polling update rate: 1 second  
Receiver timeout: 10 seconds (if connection is lost for this length of time, all relays will open)  
Typical Supply Currents

(with LEDs enabled)


(with LEDs disabled)
 
Dimensions: 4.2"(W) x 2.8"(H) x 1.125"(D)
10.7cm x 7.2cm x 2.9cm
 
Certifications: FCC: OUR-XBEEPRO
IC: 4214A-XBEEPRO